Cars with automatic gear shifting are increasingly in demand. Driving such a vehicle is not difficult, but it is important to know some of the subtleties of how to properly drive an automatic vehicle. This will avoid breakdowns and other troubles. Automatic driving lessons explain in detail how to do this.
How to start a car with Automatic transmission
Start the car in the position of the lever P, you can N. If the car does not start, then one of the reasons is that the lever is installed incorrectly. Features of how to start with an automatic transmission:
- It is important to warm up the car. At temperatures above , to distribute the oil evenly, the engine must warm up for 2 minutes; at sub-zero temperatures, it will take 10 minutes. In winter, the transmission is also warmed up. To do this, turn on mode D and press the brakes for 20-30 seconds, then switch to mode R – 30 seconds. The procedure is repeated a couple of times, after which the gas is squeezed out a little when installing the car on the handbrake.
- Activate one of the established modes. To do this, switch the lever until there is a slight push. (It is important to remember that if there is no push and you squeeze the gas, then such actions will result in a breakdown).
Therefore, in order to avoid trouble, it is important to do everything right. If the engine breaks down, it is not difficult to fix it, but there will be problems with the automatic transmission. It is not difficult to master the subtleties of how to start a car automatically; with time, experience will come in this matter.
How to drive off with an automatic transmission
The rules for driving an automatic transmission are not complicated. To do this, first press the brake all the way and move the control lever from mode P to D or R (when moving backwards). Next, lower the handbrake and slowly release the brakes, the car will begin to move. To add speed, you can smoothly press the gas. It is important to remember that you only need to operate the pedals with one foot, so that there is no temptation to press the brakes and gas at the same time.
Changing gears on automatic transmission
The gear shift occurs automatically; the driver only has to press the gas and brake pedals. To control the operation of the transmission, a lever is used. Having studied the basic modes, you can easily learn how to correctly change gears on Cheap automatic driving lessons Coventry. Here’s what driving theory says :
-
- P is intended for braking. At this time, the wheels are blocked while the engine is running. Use when parking or warming up the engine. You should not turn on the mode when driving or before every traffic light; it is better to use the brakes. Do not confuse the mode with the handbrake. The hand brake is more reliable.
- R is used to engage reverse.
- D (from the word drive – to go) is used when moving forward, and the gears are engaged automatically. Some machines are equipped with additional modes that are digitally designated. They are used when driving on different sections of the road (off-road, icy conditions, steep slopes, etc.). There is also a designation L or B for driving at a reduced speed (it is forbidden to turn on at a speed of less than 30 km/h).
- O/D allows you to use higher speeds, which are usually in the off state. The button corresponds to 5 gears on the mechanics. It is not recommended to use it regularly.
Automatic gear shifting occurs when driving, when the gas pedal is depressed, and when mode D or R is turned on. Smooth release reduces the speed of the car.
Automatic engine braking
For an inexperienced driver, operating an automatic transmission after a manual transmission can lead to some errors. It would be correct to fully press the brakes and turn on mode D before stopping the vehicle. When stopping for a long time, set the mode from P to N and you can remove your foot from the pedals after braking.
Recommended Article: Power of Nursery Rhymes in Early Learning
